Create IPSec Tunnel or a WireGuard Peer
After creating a VPN Gateway, you can create a Tunnel or a Peer based on your chosen VPN Gateway protocol.
To create tunnels or peers, follow these steps:
1. In the DCD, go to Menu > Network > VPN Gateway under Connectivity.
2. On the VPN Gateways page, click Create Tunnels or Create Peers based on the chosen VPN Gateway protocol.


3. Enter the following details:
Enter the following details in the Create IPSec Tunnel page:
Properties
Tunnel name: Enter a tunnel name.
Description: (Optional). Enter a description.
Remote host: Enter a valid public IPv4 address or an Fully Qualified Domain Name (FQDN).

Authentication
Pre-shared key (PSK): Enter a valid key or click Generate to automatically generate a key.
Initial Exchange (IKE_SA_INIT) Settings
Select an appropriate value from the drop-down list for the following:
Diffie-Hellman Group
Encryption Algorithm
Integrity Algorithm
Lifetime: Specify a value starting from 3600 seconds to a maximum of 604800 seconds.
Child SA/IPSec SA Settings (ESP)
Select an appropriate value from the drop-down list for the following:
Diffie-Hellman Group
Encryption Algorithm
Integrity Algorithm
Lifetime: Specify a value starting from 600 seconds to a maximum of 86400 seconds.

Network CIDRs
Enter the following details:
Cloud Network CIDRs: Specify up to 20 IPv4 or IPv6 network addresses, separated by commas, on IONOS Cloud that can connect to the tunnel.
Peer Network CIDRs: Specify up to to 20 IPv4 or IPv6 addresses, separated by commas, on the peer side that can connect to the tunnel.
4. Click Save to save the configuration.
Last updated
Was this helpful?