NatgatewayRuleAdd

Adds a Rule to a Nat Gateway under a data center.

knife ionoscloud natgateway rule add (options)

Available options:

Required options:

• datacenter_id

• natgateway_id

• name

• source_subnet

• public_ip

    ionoscloud_url: --url URL
        the Ionoscloud API URL

    extra_config_file: --extra-config EXTRA_CONFIG_FILE_PATH, -e EXTRA_CONFIG_FILE_PATH
        path to the additional config file

    datacenter_id: --datacenter-id DATACENTER_ID, -D DATACENTER_ID
        name of the data center (required)

    natgateway_id: --natgateway-id NATGATEWAY_ID, -G NATGATEWAY_ID
        iD of the NAT Gateway (required)

    name: --name NAME, -n NAME
        name of the NAT gateway rule (required)

    type: --type TYPE, -t TYPE
        type of the NAT gateway rule

    protocol: --protocol PROTOCOL, -p PROTOCOL
        protocol of the NAT gateway rule. Defaults to ALL. If protocol is 'ICMP' then target_port_range start and end cannot be set.

    source_subnet: --source SOURCE_SUBNET
        source subnet of the NAT gateway rule. For SNAT rules it specifies which packets this translation rule applies to based on the packets source IP address. (required)

    public_ip: --ip PUBLIC_IP, -i PUBLIC_IP
        public IP address of the NAT gateway rule. Specifies the address used for masking outgoing packets source address field. Should be one of the customer reserved IP address already configured on the NAT gateway resource (required)

    target_subnet: --target TARGET_SUBNET
        target or destination subnet of the NAT gateway rule. For SNAT rules it specifies which packets this translation rule applies to based on the packets destination IP address. If none is provided, rule will match any address

    target_port_range_start: --port-start PORT_RANGE_START
        target port range start associated with the NAT gateway rule

    target_port_range_end: --port-end PORT_RANGE_START
        target port range end associated with the NAT gateway rule

    ionoscloud_username: --username USERNAME, -u USERNAME
        your Ionoscloud username

    ionoscloud_password: --password PASSWORD, -p PASSWORD
        your Ionoscloud password

    ionoscloud_token: --token PASSWORD
        your Ionoscloud access token

Example

knife ionoscloud natgateway rule add --url URL --extra-config EXTRA_CONFIG_FILE_PATH --datacenter-id DATACENTER_ID --natgateway-id NATGATEWAY_ID --name NAME --type TYPE --protocol PROTOCOL --source SOURCE_SUBNET --ip PUBLIC_IP --target TARGET_SUBNET --port-start PORT_RANGE_START --port-end PORT_RANGE_START --username USERNAME --password PASSWORD --token PASSWORD